Gavita Pro 600W  EL / 400 Volt HPS Lamp

Gavita Pro 600W EL / 400 Volt HPS Lamp

SKU: 126033
£44.49
Gavita Pro 600W  EL / 400 Volt HPS Lamp

This lamp is for use with a 400v ballast or complete fixture. Do not use it with a standard 230v ballast!

Replaces the Lamp Supplied with 600w 400v Gavita Pro Systems

The Gavita Pro 600W W EL / 400 Volt HPS Lamp has been designed specifically for 400 Volt / 600 Watt lighting systems as a replacement for the Philips Master Greenpower. When used in a Pro HPS 400 Volt / 600 Watt system, this lamp will outperform virtually all other 600 Watt lamps and lasts for approximately a year!

  • A replacement for the Philips Master Greenpower Lamp
  • A superb lamp, specifically for use with Pro HPS 400 Volt / 600 Watt lighting systems only
  • Produces the most umols (plant useable light) of any 600w lamp for flowering
  • Biggest yielding lamp 600 Watt HPS lamp available
  • Lasts for up to a year

Contains:

1 x Gavita Pro 600W / 400 Volt HPS Lamp

How the Gavita Pro 600W / 400 Volt HPS Lamp Works:

The light spectrum output of the Gavita Pro Plus EL lamp:

The black line in the graph above represents the "McCree Curve", which gives a relative indication of how efficiently a plant uses the different colours in the light spectrum to photosynthesise with.

For more information about the above graph check out our blog

 

The Gavita Pro 600W / 400 Volt HPS Lamp is a single-spectrum lamp with the most plant-useable light output of just about any 600 Watt lamp on the market. The lamp produces light only in the orange/red part of the spectrum for heavy flowering. It has been specifically designed to make the most of your HPS Pro (400 Volt / 600 Watt) system where it will produce more plant-useable light photons, of a better spectrum, than any other 600 Watt lamp available.

How to Use the Gavita Pro 600W / 400 Volt HPS Lamp:

Using a clean cloth to hold the lamp, screw the lamp into the E40 bulb-holder fitting of your Pro HPS 400 Volt / 600 Watt reflector until it will turn no further. It is important that the lamp is screwed very firmly into the holder. Failure to fit the lamp tightly will cause arcing inside the holder between the centre connector and the contact on the lamp. This will melt the solder contact on the lamp and irreparably damage it. Ensure the lamp is completely clean and free of dirt, grease and finger-prints etc. before switching it on.

WARNING 1: Once the lamp is switched on it runs extremely hot. As with all high pressure sodium and metal halide bulbs it is necessary to avoid touching the lamp with anything such as fingers or plants as this may cause severe burns or fires. In particular avoid sprays or liquids coming into contact with the lamp as this may cause premature failure or even an explosion.

WARNING 2: This lamp MUST ONLY be used in a a 400 volt / 600 watt system. If it is used in other types of lighting system, then it will either not work or could cause explosions, fire or damage to equipment.