Free Delivery, when you spend £99
Interest Free Payments with
Buy now pay later with

E40 to CDM Converter / Adapter

0-day delivery
Lots In stock
Delivery within 1-3 working days
  • Save on your electricity bills and produce the same yields!
  • CDM - full spectrum light output that plants love
  • Less heat output than equivalent HPS lights
  • Gives off 1.9 umols PPF per watt - amazingly efficient!

Convert your reflector with full spectrum 315w CDM that gives more yield per watt than HPS!

CDM (Ceramic Discharge Metal-Halide) lamps give out an intense full spectrum light that plants love. The E40 to CDM Converter / Adapter converts your current reflectors E40 lamp fitting for use with a CDM lamp. CDM lamps give you incredible full spectrum light which gives much better quality than you would expect from HPS lighting alone.

How the E40 to CDM Converter / Adapter Works

The E40 to CDM Converter / Adapter simply screws into your reflectors E40 lamp fitting, this then lets you use CDM lamps alongside a specific CDM ballast such as the Maxibright Daylight.

To see our full CDM / CMH Grow Light Kits range, click here


1 x E40 to CDM Converter / Adapter

How to use the E40 to CDM Converter / Adapter

PLEASE NOTE: The 315w CDM lamps need to be bedded in as follows: on first illumination the lamp needs to be run continuously for a minimum of 15 minutes. This will allow the metals within the lamp to fuse correctly.

If the above is not adhered to, lamp warranty claims will be void.

If the above is not adhered to, lamp warranty claims will be void.

Simply screw the convertor into your current reflectors E40 fitting and screw the CDM lamp into the convertor in your reflector as tightly as possible by gripping the lamp with a clean, dry cloth. If the lamp is not screwed in as tightly as possible, arcing can occur between the centre contact of the lamp and the lamp-holder. This melts the solder contact on the bottom of the lamp, causing damage and making it un-useable. Make sure that the lamp is clean and completely free of fingerprints and other contaminants. Finally, make sure that your reflector is hung at the correct height for your CDM Lamp.

The wattage of your ballast MUST match the wattage of the lamp you are using or there will be a high risk of fires or equipment damage. Only use the Maxibright ballast that comes with this kit for firing up the CDM lamps. Never use a HPS or MH ballast with CDM lamps. Connect the mains plug into an electrical outlet socket and switch on. The Maxibright CDM ballast will start-up and light the lamp.

Write Your Own Review
You're reviewing:E40 to CDM Converter / Adapter