SMSCom Mk2 6.5-Amp Sensor for Smart Controller

0-day delivery
Lots In stock
Delivery within 1-3 working days
  • 3.0m long temperature sensor
  • Upgrades your standard SMSCom 6.5-Amp Mk2 Plug-In Smart Fan Speed Controller
  • Can be used as a direct replacement for a damaged or faulty sensor
  • Easy to install

SMSCom Mk2 6.5-Amp Sensor for Smart Controller

The SMSCom Mk2 6.5-Amp Sensor is a replacement for a damaged or faulty sensor on a SMSCom 6.5-Amp Mk2 Plug-In Smart Fan Speed Controller. It can also be used as an upgrade to the SMSCom 6.5-Amp Mk2 Plug-In Smart Fan Speed Controller so that it can take readings remotely.


How the SMSCom Temperature Sensor Works

SMSCom Fan Speed Controllers regulate the amount of air extracted from the grow area by increasing or decreasing the output of in-line duct fans at any given time to maintain a user specified climate. The temperature probe is placed near the canopy of your plants, and sends highly accurate data to the on-board computer inside the SMSCom unit, in order for it to make suitable adjustments. At 3.0 metres long, this sensor (otherwise referred to as the temperature probe) provides a lot more flexibility than the 2.0 metre version supplied as standard with many SMSCom units. Those with larger indoor gardens have the freedom to position the sensor anywhere they choose in the grow area and mount the controller itself in the most convenient place.

To see our full Fan Speed Controllers range, click here


1 x SMSCom Mk2 6.5-Amp Sensor

Check out the SMSCom 6.5-Amp Mk2 Plug-In here.

How to Use the SMSCom Temperature Sensor

Electrical work should only ever be carried out by a technically competent person. Do not attempt to peform this process without the required training and experience. This guide details how to use this item with the 4.5amp SMSCom Pro.

Position your SMSCom on a flat surface. Remove the 4 screws that sit in each corner of the fascia.

Locate the connector block that’s wired up to the original temperature sensor and make a note of which coloured wire goes into which section of the connector block. Loosen the screws and remove the two wires.

Loosen the electrical sealing gland on the bottom of the unit that secures the sensor in place and pull the original temperature sensor through, removing it altogether.

Thread the brown and white wires of the new 5.0m temperature sensor through the sealing gland and into the unit itself. Screw them into the connector block so that they match the wiring of the original sensor.

Tighten the sealing gland back up to secure the sensor wire in place, leaving enough slack to comfortably refit the front panel. Screw the front panel back in place.

All SMSCom products come with a 5-year manufacturer's warranty starting from the date purchased. The warranty consists of a 1-year direct replacement term and a further 4-year warranty on repairs, which you can take advantage of by visiting the SMSCom website. To receive the full term of your warranty, you must be able to provide proof of purchase.

From September 1st 2016, all products will be supplied with a warranty registration card containing a unique number. To activate your warranty, you'll need to visit and fill in the registration form. If this procedure is not followed, then the date of manufacture becomes the leading date for your warranty.

Write Your Own Review
You're reviewing:SMSCom Mk2 6.5-Amp Sensor for Smart Controller