Philips Master GreenPower 600W / 230 Volt Son-T PIA CG-T HPS Lamp

Philips Master GreenPower 600W / 230 Volt Son-T PIA CG-T HPS Lamp

SKU: 126016
£43.95
Philips Master GreenPower 600W / 230 Volt Son-T PIA CG-T HPS Lamp

Philips Master Greenpower 600W / 230 Volt SON-T HPS Lamp

This Philips Master GreenPower Son-T PIA CG-T 600W / 230 Volt HPS Lamp is for 230v/240v must only be used with 230v/240v ballasts (not 400V which is required for the GreenPower 400v Pro EL lamps). This lamp will outperform virtually all other 600 Watt 230 Volt lamps and comes with a fearsome reputation!

  • A superb lamp, specifically for use with 230 Volt / 600 Watt lighting systems
  • Genuine Philips Master GreenPower Son-T HPS Lamp
  • Produces a huge 1100 µmols/sec
  • One of the biggest yielding 600 Watt 230 Volt HPS lamps available

Contains

1 x Philips Master GreenPower Son-T PIA CG-T  600W / 230 Volt HPS Lamp

Voltage: 230 Volts
Wattage: 600 Watts
Kelvin colour: 2000K
Total PAR light output: 1100 µmols/sec

Want more blue light in your flowering period? Check out our Complete 315w CDM Grow Light Kits.

How the Philips Master Greenpower Son-T 600W / 230 Volt HPS Lamp Works

Why not take a look at our 230V 600W HPS Lamp Shootout Blog Here

The Philips Master GreenPower 600W / 230 Volt HPS Lamp is a single-spectrum lamp with the most plant-useable light output of just about any 600 Watt 230 Volt lamp on the market. The lamp produces light mostly in the orange / red part of the spectrum for heavy flowering however, it does produce some light in the blue part of the spectrum making it suitable for vegging. It has been specifically designed to make the most of your 230 Volt / 600 Watt system where it will produce more plant-useable light photons, of a better spectrum, than almost any other 600 Watt lamp available.

Here is the light spectrum output:

How to Use the Philips Master Greenpower Son-T PIA CG-T 600W / 230 Volt HPS Lamp

Using a clean cloth to hold the lamp, screw the lamp into the E40 bulb-holder fitting of your reflector until it will turn no further. It is important that the lamp is screwed very firmly into the holder. Failure to fit the lamp tightly will cause arcing inside the holder between the centre connector and the contact on the lamp. This will melt the solder contact on the lamp and irreparably damage it. Ensure the lamp is completely clean and free of dirt, grease and finger-prints etc. before switching it on. Only use this lamp with a 230 Volt output ballast. DO NOT use it with a 400 volt ballast

WARNING 1: Once the lamp is switched on it runs extremely hot. As with all high pressure sodium and metal halide bulbs it is necessary to avoid touching the lamp with anything such as fingers or plants as this may cause severe burns or fires. In particular avoid sprays or liquids coming into contact with the lamp as this may cause premature failure or even an explosion.

Note: Packaging may vary

Look for similar items