Uvonair CD-1200 In-Duct (12") Ozone Generator
Ozone neutralises odours and inhibits moulds and bacteria in the air. The Uvonair CD-1200 works in your 12 inch (315mm) outlet ducting, producing enough ozone to clean the air coming out of areas up to 100000 cubic feet (3000 cubic metres). Great for peace of mind when growing plants that create a lot of odour.
- Uvonair – Makers of high quality ozone generators
- Uvonair CD-1200 – for use in 12 inch (315mm) ducting
- Uses corona discharge to produce 5800mg of ozone per hour
- Can be switched between high and low output
- Professional quality
- Drastically reduces odours exiting the outlet ducting
- Incredibly effective for rooms up to 100000 cubic feet (3000 cubic metres)
- Uses only 90 Watts
The Uvonair CD-1200 In-Duct Ozone Generator Contains:
1 x Uvonair CD-1200 In-Duct (12") Ozone Generator
How the Uvonair CD-1200 In-Duct Ozone Generator works:
The Uvonair CD-1200 In-Duct Ozone Generator is a professional quality ozone generator that utilises three corona discharge tubes to produce up to 5800mg of ozone per hour. The Uvonair CD-1200 is designed to be inserted into a 12 inch (315mm) extraction system directly after the carbon filter and fan. The ozone produced by the Uvonair CD-1200 is then mixed with the air leaving the grow-room as it travels down the ducting, neutralising odours, bacteria and mould spores that it comes into contact with, making the air considerably cleaner and fresher-smelling. The Uvonair CD-1200 has a power switch which enables it to be switched between low, off and high. If the room size is much smaller than 100000 cubic feet (3000 cubic metres) then running the Uvonair CD-1200 in low mode may be adequate.
Using the Uvonair CD-1200 In-Duct Ozone Generator:
The Uvonair CD-1200 is designed to be used in a traditional 12 inch (315mm) grow-room extraction system consisting of a duct-fan, filter and ducting. Although the Uvonair CD-1200 is superb at reducing odours, it should always be used in combination with a quality carbon filter (we recommend the best - a Rhino Pro, of course) to ensure complete elimination of smells. The Uvonair CD-1200 is 12 inches (315mm) in diameter and can easily be connected into 12 inch (315mm) ducting and secured with a Duct Clip (available separately) on each side. The CD-1200 should be connected into the ducting straight after the duct-fan and there should be several metres of ducting after it, preferably at least 5 metres. This gives the ozone plenty of chance to mix with the air and to clean it as it goes down the ducting before coming out of the end.
The Uvonair CD-1200 should be switched on whenever the duct-fan is on and should be switched off when the duct-fan is off. The Uvonair CD-1200 can be wired to the same electrical feed as the duct-fan as long as a fan speed controller is not being used. If a fan speed controller is being used then the Uvonair CD-1200 should not be connected to this supply as it will not work. In this case, the Uvonair CD-1200 will need it’s own mains electrical supply.
Ozone can be harmful to humans and animals so the air leaving the ducting should not blow directly into areas where it likely to be inhaled. Instead, the end of the ducting should be located somewhere that the ozone-laden air can disperse before it is likely to be inhaled by humans or animals.
The Uvonair CD-1200 is incredibly effective at reducing odours. However, it is NOT a replacement for a quality carbon filter which should still be used to in your extraction system.
Warnings: Do not inhale the air from directly in front of the generator or the end of the ducting as this will be very rich in ozone and therefore could be a hazard to health. Children and animals should be kept out of any area which may contain elevated levels of ozone.
The corona discharge type Uvonair ozone generators do not require maintenance or scheduled replacement of any parts.
Uvonair CD-1200 Power Consumption: 90 Watts
- 12-Inch (315mm)